YAMAGULL v1.0 Jan 31, 2019 15:17:48 GMT -5
Post by blues90 on Jan 31, 2019 15:17:48 GMT -5
Looks good ; Are you just gluing the finger board extension to the top and using the seagull bolts for the heel? I know there is a formula for determining neck angle . Some times if you need to tilt the neck back so the top of the bridge is even with the top of the frets it brings to finger board extension higher off the top and you need to make a tapered shim to fit under the extension or it might either pull the extension down or the top up . It's a pretty tricky job just doing a neck reset on a guitar with the original neck and body, You are going even further out of the box . I'm sure you will get it setup just fine , just takes time and some breaks /time off.